Kenwood KDC MP205 Manual

The Kenwood KDC MP205 is a car stereo receiver with CD/MP3/WMA playback, built-in amplifier, detachable faceplate, AM/FM tuner, auxiliary input, front panel USB connectivity, and remote control capability. Features include 50W x 4 max power output, LCD display, preset stations, audio adjustments, and security features. Below are key sections for features, installation, operation, settings, and troubleshooting.

1. Features at a Glance 2. Installation 3. Basic Operation 4. Specifications 5. Controls and Functions 6. Audio Settings 7. Media Playback 8. Security Features 9. Care & Maintenance 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Main unit with detachable faceplate, remote control, wiring harness, mounting sleeve, user manual.

Feature	Description
CD/MP3/WMA Playback	Plays audio CDs and compressed audio files
AM/FM Tuner	30 station presets (18 FM, 12 AM)
Auxiliary Input	3.5mm front panel input for external devices
USB Connectivity	Front panel USB port for flash drives
Detachable Faceplate	Security feature to prevent theft
Power Output	50W x 4 channels maximum
LCD Display	Backlit display with track information
Audio Controls	Bass, treble, balance, fader adjustments
Remote Control	Optional remote control operation
Power Requirements	12V DC vehicle electrical system

Installation

Unpack and verify all components. Professional installation recommended.

Disconnect vehicle battery negative terminal for safety.
Remove existing stereo following vehicle manufacturer instructions.
Connect wiring harness: Match color-coded wires (red - ignition, yellow - battery, black - ground).
Connect antenna cable and speaker wires.
Slide unit into mounting sleeve and secure with provided brackets.
Reconnect battery and test operation.

WARNING! Always disconnect battery before installation. Ensure proper fuse rating for vehicle electrical system.

Basic Operation

Power on unit by pressing POWER button. Insert faceplate if detached.

Source selection: Press SOURCE to cycle through CD, Tuner, AUX, USB.
Volume control: Turn VOLUME knob or use remote control.
CD operation: Insert disc, playback starts automatically.
Tuner operation: Press BAND to select AM/FM, use TUNE to find stations.
Preset stations: Store stations by holding preset button for 2 seconds.

CAUTION! Do not operate while driving. Set all controls before driving.

Specifications

Power Output: 50W x 4 max (22W x 4 RMS)
Frequency Response: 20Hz - 20kHz
Signal-to-Noise Ratio: >90dB
Supported Media: CD, CD-R, CD-RW, MP3, WMA
Tuner Sensitivity: FM: 10.3 dBf, AM: 22 dB
Display: LCD with orange illumination
Power Supply: 12V DC negative ground
Dimensions: DIN size (178mm x 50mm)
Operating Temp: -20°C to +60°C

Controls and Functions

Front Panel: POWER, EJECT, VOLUME knob, SOURCE, BAND, TUNE/TRACK buttons, AUX input, USB port.

Remote Functions: POWER, VOLUME, MUTE, SOURCE, TRACK UP/DOWN, PRESET, DISPLAY.

Basic Operations: Press SOURCE to select mode (TUNER/CD/AUX/USB). Press BAND to switch between AM/FM. Use TUNE/TRACK for station/chapter selection. Hold buttons for advanced functions.

Audio Settings

Access audio menu by pressing and holding AUDIO button.

Bass/Treble: Adjust frequency response (-6 to +6 levels)
Balance/Fader: Control speaker output distribution
Loudness: Boost low frequencies at low volume
EQ Presets: FLAT, POP, ROCK, JAZZ, CLASSICAL
Subwoofer Control: Adjust subwoofer output level

Tip: Reset to factory settings by holding RESET button with small pin.

Media Playback

Supports CD-DA, CD-R, CD-RW, MP3, WMA formats.

CD Playback: Insert disc, auto-play begins. Use TRACK buttons for navigation.
MP3/WMA: Supports folder navigation, ID3 tag display.
USB Playback: Connect USB device, select USB source.
AUX Input: Connect external audio device to 3.5mm jack.
Repeat/Random: Press RPT or RDM for playback modes.
Fast Forward/Rewind: Hold TRACK buttons during playback.

WARNING! Do not use damaged discs. Keep USB devices secure while driving.

Security Features

Detachable Faceplate: Remove for theft prevention. Security Code: 4-digit code prevents unauthorized use after power loss.

Setting Code: Enter desired code in security menu.
Code Entry: Input code if "CODE" appears on display.
Code Reset: Contact authorized service center if code forgotten.

Care & Maintenance

Clean with soft, dry cloth. Avoid chemical cleaners. Store faceplate in protective case.

CAUTION! Do not expose to extreme temperatures or moisture. Keep discs clean and scratch-free.

Regulatory Information

FCC Part 15: Class B digital device compliant. CE marked for European market. Copyright © Kenwood Corporation. For support, visit www.kenwood.com or contact authorized service centers. Disposal: Follow local regulations for electronic waste.

Troubleshooting

Symptom	Possible Cause	Corrective Action
No power	Wiring/fuse	Check power connections; replace fuse; verify battery connection
No sound	Volume/mute	Check volume setting; verify mute is off; check speaker connections
CD won't play	Disc/damage	Check disc for damage; clean lens; ensure compatible format
Poor radio reception	Antenna/position	Ensure antenna connected; check antenna amplifier power
USB not recognized	Format/compatibility	Use FAT32 format; check device compatibility; try different USB device
Display shows "CODE"	Security code	Enter correct security code; contact dealer if forgotten

Reset: Use reset button or disconnect battery for 10 minutes.

Service: Contact authorized Kenwood service center for repairs.