Kenwood TK 3202 Manual

The Kenwood TK 3202 is a professional VHF two-way portable radio designed for commercial and industrial use. It features robust construction, clear audio quality, multiple channel capacity, programmable functions, and reliable communication performance. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Durable housing, LCD display, programmable buttons, antenna, battery pack, charging contacts.

Installation

Unpack and inspect contents. Install battery and antenna.

1. Install battery: Align battery with contacts, slide until it clicks into place.
2. Attach antenna: Screw antenna clockwise onto antenna connector.
3. Charge battery: Place radio in charger until fully charged.
4. Install accessories: Attach belt clip or other accessories as needed.

WARNING! Use only Kenwood-approved batteries and accessories. Do not use damaged batteries.

First-Time Setup

Power on radio; configure basic settings.

1. Turn on: Rotate volume knob clockwise to power on.
2. Select channel: Use channel selector knob or up/down buttons.
3. Adjust volume: Rotate volume knob to desired level.
4. Set squelch: Adjust squelch control to eliminate background noise.
5. Program channels: Use programming software to set frequencies and functions.

CAUTION! Ensure proper programming before use. Incorrect settings may cause interference.

Specifications

• Frequency Range: VHF 136-174 MHz
• Channels: 128 maximum
• Power Output: 5W (high), 1W (low)
• Battery Life: Approx. 10 hours (typical use)
• Dimensions: Compact portable size
• Weight: Lightweight with battery
• Operating Temp: -30°C to +60°C
• IP Rating: IP54 dust and water resistant
• Modulation: 16KΦF3E / 11KΦF3E
• Audio Output: 500mW typical

Controls and Settings

Front Panel: Power/Volume knob, Channel selector, PTT button, Programmable keys.

Display: Channel number, battery indicator, transmit indicator, scan status.

Basic Functions: Power on/off, volume control, channel selection, PTT operation. Advanced Functions: Scan, monitor, programmable keys, tone functions, power level selection.

Programming and Configuration

Requires KPG-89D programming software and programming cable.

1. Install programming software on PC.
2. Connect radio to PC using programming cable.
3. Read current data from radio.
4. Program frequencies, tones, and functions.
5. Write data to radio and verify.

Tip: Backup current programming before making changes.

Operation

Basic radio operation procedures.

1. Transmit: Press and hold PTT button, speak clearly into microphone.
2. Receive: Release PTT button to listen.
3. Channel change: Use channel selector or up/down buttons.
4. Volume adjustment: Rotate volume knob.
5. Scan: Press scan button to activate scanning function.
6. Monitor: Press monitor to open squelch temporarily.
7. Power level: Select high/low power as needed.

WARNING! Transmit only when necessary. Follow local regulations.

Maintenance

Regular maintenance ensures optimal performance.

1. Clean exterior with soft, dry cloth.
2. Check antenna for damage.
3. Inspect battery contacts.
4. Test functions regularly.
5. Charge battery as needed.

CAUTION! Do not use solvents or abrasive cleaners. Keep away from moisture.

Regulatory Information

FCC Part 90: Certified for land mobile radio service. Compliance with relevant telecommunications standards. Copyright © Kenwood Corporation. For support, contact authorized Kenwood dealer or visit www.kenwood.com.

Troubleshooting

Reset: May require reprogramming. Consult programming manual.

Service: Contact authorized Kenwood service center.