Kenwood TK 350 Manual

The Kenwood TK 350 is a professional VHF/UHF two-way portable radio designed for commercial and industrial use. This radio features robust construction, multiple channel capacity, programmable functions, and reliable communication performance. Below are key sections covering safety, features, operation, programming, maintenance, and troubleshooting.

Features at a Glance

Key components: Durable housing, LCD display, programmable buttons, antenna, battery pack, and belt clip.

Installation and Setup

Unpack and inspect contents. Install battery and antenna before first use.

1. Battery Installation: Align battery with radio contacts and slide until it clicks into place.
2. Antenna Installation: Screw antenna clockwise onto antenna connector until secure.
3. Belt Clip: Attach belt clip to rear of radio for portable carrying.
4. Charging: Place radio in charging cradle for initial charge (8-10 hours recommended).

WARNING! Do not operate radio while charging. Ensure proper antenna installation before transmitting.

Basic Operation

Power on radio; select desired channel and begin communication.

1. Power On/Off: Rotate volume knob clockwise to power on.
2. Volume Control: Rotate knob to adjust audio level.
3. Channel Selection: Use channel selector knob or up/down buttons.
4. Transmit: Press and hold PTT (Push-to-Talk) button while speaking.
5. Receive: Release PTT button to listen to incoming transmissions.

CAUTION! Transmit only when necessary and follow FCC regulations for your license class.

Specifications

• Frequency Range: VHF 136-174 MHz / UHF 400-470 MHz
• Channel Capacity: 128 channels
• Output Power: 5W VHF / 4W UHF (high power), 1W (low power)
• Modulation: 16KΦF3E / 11KΦF3E
• Antenna Impedance: 50 ohms
• Power Supply: 7.2V DC (battery pack)
• Battery: 1500mAh Ni-MH (standard)
• Dimensions: 58(W) x 130(H) x 37(D) mm
• Weight: Approx. 420g (with battery and antenna)
• Operating Temp: -30°C to +60°C

Controls and Functions

Front Panel: Volume knob, channel selector, LCD display, PTT button, programmable function keys.

LCD Display: Shows channel number, battery level, transmit indicator, and status icons.

Programmable Functions: Monitor, scan, power level selection, timeout timer, busy channel lockout, VOX, and more via programming software.

Programming and Configuration

Radio requires programming via KPG-89D software and programming cable.

1. Install KPG-89D software on Windows PC.
2. Connect radio to PC using programming cable KPG-22 or KPG-36.
3. Read current configuration from radio.
4. Program frequencies, tones, and functions as required.
5. Write configuration back to radio.

Tip: Always backup current configuration before making changes.

Battery and Charging

Standard battery: 1500mAh Ni-MH. Charging time: 8-10 hours for full charge.

1. Place radio in charging cradle ensuring proper contact.
2. Charger LED indicates charging status (red=charging, green=complete).
3. Battery life: 10 hours typical use at high power setting.
4. Battery saving: Use low power mode when possible to extend battery life.

WARNING! Use only Kenwood-approved batteries and chargers. Do not disassemble battery packs.

Maintenance and Care

Clean exterior with soft, dry cloth. Avoid chemicals and solvents.

CAUTION! Do not immerse radio in water. Keep away from extreme temperatures and moisture.

Regulatory Information

FCC Part 90: This device complies with Part 90 of the FCC rules for Land Mobile Radio services. Operation is subject to proper licensing. Copyright © Kenwood Corporation. For support, contact authorized Kenwood dealer or visit www.kenwood.com.

Troubleshooting

Reset: Requires reprogramming via software.

Service: Contact authorized Kenwood service center for repairs.