Kenwood TK 372G Manual

The Kenwood TK 372G is a professional-grade VHF two-way portable radio designed for commercial and industrial use. Featuring robust construction, 16 channels, programmable functions, and reliable communication capabilities. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Durable housing, LCD display, programmable buttons, antenna, battery pack, charging contacts.

Installation

Unpack and inspect contents. Install battery and antenna.

1. Install battery: Align battery contacts, slide until click.
2. Attach antenna: Screw antenna clockwise until secure.
3. Charge battery: Place in charger until indicator shows full.
4. Attach accessories: Clip, speaker mic, etc.

WARNING! Do not transmit without antenna attached. Ensure battery is properly installed.

First-Time Setup

Power on radio; initialize settings.

1. Power on: Rotate volume knob clockwise.
2. Select channel: Use channel selector knob.
3. Set squelch: Adjust to eliminate background noise.
4. Program channels: Use programming software for frequencies.
5. Test transmission: Press PTT and speak clearly.

CAUTION! Ensure proper programming before use in licensed frequencies.

Specifications

• Frequency Range: VHF 136-174 MHz
• Channels: 16 programmable
• Power Output: 5W (High), 1W (Low)
• Battery Life: Approx. 10 hours (5-5-90 duty cycle)
• Dimensions: 58(W) x 130(H) x 37(D) mm
• Weight: 350g with battery
• Operating Temp: -30°C to +60°C
• IP Rating: IP54 dust and water resistant
• Modulation: 16KΦF3E / 11KΦF3E

Controls and Settings

Front Panel: Volume knob, channel selector, PTT button, programmable buttons.

Display: Channel number, battery level, transmit indicator, scan status.

Settings: Squelch levels, power settings, scan lists, time-out timer, VOX sensitivity. Programming: Requires KPG-89D software and programming cable.

Connecting Devices

Accessories: Speaker mic, headphones, programming cable, charger.

1. Turn off radio before connecting accessories.
2. Connect programming cable to PC and radio accessory port.
3. Attach speaker mic to accessory connector.
4. Use approved accessories only.

Tip: Ensure connectors are clean and properly seated.

Programming and Operation

Requires KPG-89D programming software.

1. Install software on Windows PC.
2. Connect radio with programming cable.
3. Read current data from radio.
4. Program frequencies, tones, and functions.
5. Write data to radio.
6. Verify programming by testing channels.
7. Use channel selector to switch between programmed channels.
8. Press PTT to transmit; release to receive.

WARNING! Only program frequencies for which you have license. Save original programming.

Accessibility Features

VOX: Hands-free operation. Monitor: Open squelch to hear weak signals. Backlight: Adjustable display illumination. Tones: Programmable CTCSS/DCS for private communications.

Care & Cleaning

Turn off and remove battery before cleaning. Use soft, dry cloth. For stubborn dirt, use cloth dampened with mild soap solution.

CAUTION! Do not use solvents or abrasives. Keep away from extreme temperatures and moisture.

Regulatory Information

FCC Part 90: Certified for land mobile radio service. Compliance with relevant national regulations. Copyright © Kenwood Corporation. For support, visit www.kenwood.com or contact authorized service centers.

Troubleshooting

Reset: Use programming software to reset to factory defaults if needed.

Service: Contact authorized Kenwood service center for repairs.