Kenwood TS-130SE Manual

The Kenwood TS-130SE is a high-performance amateur radio transceiver covering multiple HF bands with SSB, CW, and AM modes. Features include built-in power supply, digital frequency display, noise blanker, RF attenuator, and adjustable RF power output. Below are key sections for safety, features, installation, operation, and maintenance.

Features at a Glance

Key components: Main transceiver unit, microphone connector, antenna terminals, power supply input, speaker output.

Installation

Unpack and inspect contents. Place on stable surface with adequate ventilation.

1. Connect antenna: Use proper coaxial cable to antenna terminals.
2. Connect power: Use appropriate AC power cord to power input.
3. Connect microphone: Plug microphone into 8-pin connector.
4. Connect speaker: Use external speaker if desired.

WARNING! Ensure proper grounding for safety. Use appropriate fuses in power line.

First-Time Setup

Power on transceiver; allow warm-up time.

1. Set operating frequency: Use main tuning knob to select desired band.
2. Select mode: Choose SSB, CW, or AM as needed.
3. Adjust RF power: Set appropriate power level for operation.
4. Set filters: Select IF filter bandwidth for current conditions.

CAUTION! Ensure antenna is properly connected before transmitting.

Specifications

• Frequency Range: 1.8-30 MHz amateur bands
• Modes: LSB, USB, CW, AM
• Power Output: 100W PEP SSB/CW, 25W AM
• Power Requirements: 120V AC, 50/60Hz
• Sensitivity: Better than 0.25μV for 10dB S+N/N
• Selectivity: SSB: 2.4kHz, CW: 500Hz, AM: 6kHz
• Audio Output: 2W internal speaker, external speaker jack
• Dimensions: Standard rack width, appropriate height
• Weight: Approximately 15 lbs

Controls and Settings

Front Panel: POWER, VOLUME, SQUELCH, RF GAIN, MODE SELECT, BAND SELECT, MAIN TUNING.

Additional Controls: NB (noise blanker), ATT (attenuator), AGC, VOX, RIT, CLARIFIER.

Frequency Control: Main tuning knob with digital readout. Mode Selection: LSB, USB, CW, AM. Filter Selection: Selectable IF filters for different bandwidths. Audio: Volume, squelch, RF gain controls. Special Functions: Noise blanker, RF attenuator, AGC timing.

Connecting Accessories

Antenna: Coaxial connector. Microphone: 8-pin connector. Speaker: External speaker jack. Power: AC input.

1. Turn off power before connecting accessories.
2. Use proper connectors and cables.
3. Ensure secure connections.
4. Check antenna SWR before transmitting.

Tip: Use high-quality coaxial cable for antenna connection.

Operating Procedures

Basic receiving and transmitting procedures.

1. Power on: Allow 30 seconds for warm-up.
2. Select band: Choose desired amateur band.
3. Select mode: LSB for 160m-40m, USB for 20m-10m.
4. Tune receiver: Adjust RF gain and volume.
5. Transmit: Use PTT or VOX for transmission.
6. Monitor SWR: Ensure proper antenna match.
7. Use filters: Select appropriate IF filter.
8. Adjust power: Set appropriate output level.

WARNING! Do not transmit without proper antenna connection.

Maintenance

Regular cleaning and inspection recommended.

Clean exterior with dry cloth only. Keep ventilation openings clear. Check connections periodically. Have qualified technician perform internal maintenance.

CAUTION! Disconnect power before cleaning. No user-serviceable parts inside.

Regulatory Information

FCC Part 97: Complies with amateur radio service rules. For amateur use only. Proper amateur radio license required for operation. Copyright © Kenwood Corporation. For support, contact authorized Kenwood service centers.

Troubleshooting

Service: Contact authorized Kenwood service center for repairs.